5. DMX connection and DMX protocol
5.1 DMX addressing:
5.1.1 The device is controlled by universal DMX 512 proto-
col, DMX address is the start channel used to receive instruc-
tions from the external controller. For independent control,
each xture must be assigned its unique address control
channels. For example, this device has four channel modes:
16/14, if we set the mode at standard 16 channels mode,
and there are several models need to be independently con-
trolled, we just simply address rst xture at 1, and second
xture at 16, third one at 32, etc.
If the devices have the same address, they will behave syn-
chronically.
DMX addressing is limited, don’t set the address so high that
without enough control channels for the xtures.
Display is ashing when no DMX signal is received.
5.1.4 Connection: us DMX cable with 3-pin XLR-plugs to con-
nect the controller with the xture or one xture with another.
BOMBER
ENGLISH VERSION
p. 9
To Next Page
Loading...