1. Equipment installation and precautions 1.1Machine Dimension.................................................................................... 4
1.2 Structure of Neoden K1830............................................................................................................................................5
1.3Working Area Structure...................................................................................................................................................6
1.4 Important Notice.............................................................................................................................................................8
1.5 Operation flow chart.......................................................................................................................................................9
1.6 Flow chart of making a programming file................................................................................................................... 10
2.PCB Editing............................................................................................................................................................................. 11
.....................................................................................................................................................................................................11
2.1 PCB forward settings.................................................................................................................................................12
2.1.1 Mag Fixture....................................................................................................................................................... 12
2.2 PCB Eject setting..........................................................................................................................................................13
After click “Eject”no matter under Mag fixture or Rail mode,the thimble will go down in “track section 2”,”track
section 3”begin to work and PCB will feed to back conveyor.......................................................................................... 13
2.3 PCB Forward Position Setting..................................................................................................................................... 13
3.Panelized PCB Edit................................................................................................................................................................ 14
3.1 Panelized PCB origin (SMD1 coordinate).................................................................................................................14
3.1.1 Single board................................................................................................................................................ 14
3.1.3 Mirror board................................................................................................................................................... 16
3.2 PCB angle..................................................................................................................................................................... 18
4. Coordinate information.............................................................................................................................................. 18
4.1 PCB Mark setting...................................................................................................................................................... 18
（1） Panelized mark point................................................................................................................................... 18
（2）Single mark point........................................................................................................................................... 18
4.2 Mark point alignment................................................................................................................................................ 18
4.3 Mark Point information............................................................................................................................................. 19
图（2.1.3.2-6）..................................................................................................................................................................24
5.2 Feeder setting................................................................................................................................................................27
6.Nozzle Information..................................................................................................................................................................30
7. Assembly Interface................................................................................................................................................................. 30
8.System Setup........................................................................................................................................................................... 34
.....................................................................................................................................................................................................34
8.1 Feeder Position Config.................................................................................................................................................35
8.2 Component Positions Setup..........................................................................................................................................36
8.3 Basic Configuration......................................................................................................................................................39
DEAR USERS：
PLEASE READ THIS USER MANUAL COMPLETELY BEFORE
OPERATING. THIS UNIT AND RETAIN THIS BOOKLET
FOR FUTURE REFERENCE.
2
Zhejiang NeoDen Technology Co.,Ltd.
To Next Page
Loading...
