Neomatica. LLC. Tracker ADM50 GLONASS / GPS. Rev.1.2 dated 03.10.2018
10
parameters set by the PERIOD and TRACK commands (see the Appendix A). In the absence of
communication with the server, the tracker writes information packets to the "black box" and,
upon communication with the server, carries out their unloading. In Tracker mode, the ADM50
never goes into sleep states, but has some energy-saving features.
"Statics" is a motionless device mode. In this mode, the last valid coordinate is fixed, and all
subsequent coordinates are ignored until the movement begins.
"Deep Statics" is a motionless device mode, in which GSM/GPRS and/or GLONASS/GPS
modules can be additionally switched off.
To configure the parameters of the Deep Static mode, available commands are:
TSTIME X
X – The time through which the Deep Static mode activates, in seconds.
TSMODE X,Y
X – the status of the GSM module in the Deep Static mode: 0 - off, 1 - on.
If in the Deep Statics mode the GSM module stay enabled then regardless of the
GLONASS/GPS module status the tracker will send packets with the last valid coordinate to the
server;
Y – the state of the GLONASS/GPS module in the Deep Static mode: 0 - off, 1 - on. The
parameter impacts on the navigation data availability speed when leaving the Deep Statics mode!
6 Functioning of the SOS Button
The SOS button in ADM50 can be triggered by pressing (closing) or releasing (opening).
When the SOS button triggers, activates the processing script, which includes:
• sending SMS with text «device_name ALARM» to the listed numbers. Maximum quantity of
numbers - 4.
• determining the coordinates and sending a packet with the alarm flag to the server. The
device will not exit the SOS processing script state until at least one point with an alarm flag
is sent.
The execution of the SOS button processing script state does not impact on the sleep time
timers of the Beacon mode (parameters Z and A), specified by command BTIME
To set the operating mode of the SOS button, use the command
To Next Page
Loading...