Neomatica ADM50 - Updating Software via GPRS; Updating Software via USB with Firmware File

Neomatica. LLC. Tracker ADM50 GLONASS / GPS. Rev.1.2 dated 03.10.2018
12
- connect USB cable (miniUSB/USB-A) to the terminal and Personal computer's
USB port;
- launch “ADMConfigurator” program on personal computer;
- if a more recent firmware version than the one installed on the terminal is detected,
“ADMConfigurator” program will inform you of its presence;
- press “Upgrade available”;
- in the opened tab “Notifications” press “firmware upgrade via USB”;
- after being upgraded, the terminal will be rebooted and become available for work.
WARNING! Don't switch the terminal's power off when upgrading the terminal's firmware
until the terminal is detected by the setting program. Otherwise there is a risk of damaging the
software whose recovery can be performed only in the manufacturer's office
8.2 Updating the terminal software via GPRS
To upgrade the terminal software via GPRS, it is necessary to install an active SIM-card in
the terminal, set the user's access point and mobile operator password (APN, user, pass).
Otherwise, the terminal will have remained in the mode of firmware uploading from the server
until connection attempts are over.
The upgrading process will start after the terminal receives «UPDATE» command via one of
the possible channels USB, GPRS, SMS. After having received the «UPDATE» command the
terminal connects to the upgrade server and uploads the relevant firmware.
After a successful upgrade the terminal passes to the standard operation mode with the
access point and server address settings installed before upgrading. The remained settings
should be checked after upgrade and if necessary, re-install them.
Depending on the GSM-network the upgrading process takes on average from 2 to 5
minutes. If the upgrading upload is not possible, the terminal will continue working with the
existing software.
8.3 Updating the terminal software via USB using the firmware file
Firmware file should be requested in technical support.
To upgrade the firmware via the USB interface with a firmware file, do the following:
- connect USB cable (miniUSB/USB-A) to the terminal and Personal computer's USB port;
- launch “ADMConfigurator” program on personal computer;after having connected the
terminal to the program, open the “Settings” section in the “Device” tab, press “Flash the
file”;
- press “Yes” in the popup;
- drag the firmware file in the respective field in the configurator window;