Before you start
1. Make sure that the system is suitable for the local mains voltage. Refer to the type
plate.
2. The power connection must be easily accessible. Place the system near a socket
outlet with protective earth connection.
Unpacking instructions
1. Slide the foam blocks with the system out of
the box. Use the grips in the foam blocks to pull
the blocks.
2. Lift the catch tray parts out of the foam blocks.
3. Turn the foam blocks on its side.
4. Remove the upper foam block.
5. Make sure that the following parts are
delivered:
-Document system
- Document feeder block
-Catch tray
- Accessory box
The accessory box contains:
-Power lead
- 4 supports for the document feeder
- 2x paper guide LH
- 2x paper guide RH
- 4x short (sharp) insert fingers*
- 4x long (sharp) insert fingers*
-Operator Manual
-Quick start guide
-This guide
* Note: These insert fingers (black plastic
parts) are not required during installation.
Please store these parts with the machine.
6. Lift the system and place it for example on the
optional furniture.
To Next Page
Need help?
General