Stacker Override - PF-90 only
The PF-90 automated stacker positions may need to be overrid-
den to accommodate different types of paper in order to im-
prove the outfeed stacking (see pg 19 for PF-80 manual stacker
wheel adjustments). The positions are preset at the factory and
should only be changed if needed. From the Operator Settings
screen select “Stacker Override”, and press the “ ” to select.
1. “Stacker Override Positions are preset by fold settings
only change if needed” will be displayed. Press the
“ ” to enter the stacker override setup or the “C” button
to exit.
2.
Using the “ ” buttons, select the standard fold that
the stacker position needs to be adjusted for. Press the
“ ” button to enter the selection.
3.
Select the paper size using the “ ” buttons. Press
the “ ” button to advance.
4. Adjust the stacker wheel position up or down using the
“ ” buttons. The number shown “P1” is the factory
setting for the fold type and paper size selected.
5. Press the “ ” to save. To adjust stacker settings for ad-
ditional folds, repeat steps 1 through 4.
16
© 2009 Neopost USA Inc. All rights reserved.
To Next Page
Loading...
Need help?
General
