8233D PRO-EN
Ω KΩ MΩ is unit of resistance
mV ,V is unit of voltage
µA, mA, A is unit of current
Indicate negative reading
4．Specification
4-1. General Specification
● Auto ranging DMM , that full scale is 2000 counts
● Display : 3 1/2 digit LCD display..
● Over load protection: Used the PTC protection circuit for Resistance,
frequency measurement for.
● DATA HOLD function
● Back Light
● Low battery indication
● Auto Power- OFF. : If the meter is idle for 15 minutes (idle time), the meter
automatically turns the power off. After auto power-off, pushing any of the
push button or changing the rotary switch can turn on the meter again.
NOTE: （1） After auto power off in the AC mode, if changing the rotary switch
to the DC mode, the Re-power on if disabled.
(2) The meter enters sleep mode after quto power off. If press
“HOLD” push button to re-power on in the sleep mode, the
auto power off function is disabled.
● Operating temperature & Humidity:
0 ~ 40℃ (32 ~104 ℉) & < 80% RH
● Storage temperature & Humidity:
-10 ~ 50℃ (14 ~ 122 ℉) & <70%RH
To Next Page