Copyright
This manual is an unpublished work and contains the trade secrets and confidential information of
Neptune Technology Group Inc., which are not to be divulged to third parties and may not be reproduced or
transmitted in whole or part, in any form or by any means, electronic or mechanical for any purpose, without the
express written permission of Neptune Technology Group Inc. All rights to designs or inventions disclosed
herein, including the right to manufacture, are reserved to Neptune Technology Group Inc.
Neptune engages in ongoing research and development to improve and enhance its products. Therefore,
Neptune reserves the right to change product or system specifications without notice.
Trademarks used in this manual
MACH 10 is a registered trademark of Neptune Technology Group Inc. MACH 10)R900i and MACH 10)R450i
are trademarks of Neptune Technology Group Inc. R900 and E-Coder are registered trademarks of Neptune
Technology Group Inc. R450 and ProRead are trademarks of Neptune Technology Group Inc. Other brands or
product names are the trademarks or registered trademarks of their respective holders.
FCC Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Information
This equipment complies with the FCC RF radiation requirements for uncontrolled environments. To maintain
compliance with these requirements, the antenna and any radiating elements should be installed to ensure that
a minimum separation distance of 20cm is maintained from the general population.
Professional Installation
In accordance with section 15.203 of the FCC rules and regulations, the MIU must be professionally installed
by trained utility meter installers. Changes or modifications not expressly approved by the party responsible for
compliance void the user's authority to operate the equipment.
Changes or modifications not expressly approved by the party responsible for compliance void the
user's authority to operate the equipment.
To Next Page
