Neptune APEX User Manual




Neptune APEX Specifications

General

Connectivity	Ethernet, Wi-Fi
Power Monitoring	Yes
Temperature Probe	Yes
Expandable	Yes
Power Supply	12V DC
Dosing Pump Control	Yes
Type	Aquarium Controller
Display	LCD
pH Probe	Yes
ORP Probe	Optional
Salinity Probe	Optional
Mobile App	Yes
Expandability	Modular
ORP Monitoring	Yes (with optional probe)
Salinity Monitoring	Yes (with optional probe)
Control Outlets	8
Mobile App Support	iOS and Android
Inputs	Multiple
Outputs	Multiple
Compatibility	Various aquarium equipment

Summary

Introduction to APEX Cloning

APEX Cloning Requirements

Accessing the APEX Classic Dashboard

Cloning Your APEX

Create a Configuration Backup of the OLD APEX

Save configuration settings from the original APEX to a file.

Prepare the NEW APEX

Prepare the replacement APEX by resetting and updating firmware.

Restore the Configuration Backup on the NEW APEX

Load the saved configuration backup onto the new APEX unit.

Enable REPLACEMENT MODE in the NEW APEX

Activate special mode on the new APEX for cloning.

Replace the OLD APEX with the NEW APEX

Physically disconnect old APEX and connect new APEX components.

Disable REPLACEMENT MODE

Turn off REPLACEMENT MODE on the new APEX after cloning.

Additional Steps on the NEW APEX

Perform post-cloning tasks like calibration and firmware updates.

Link the NEW APEX with APEX Fusion

Connect the new APEX to the APEX Fusion service.