EasyManuals Logo

Nespresso VERTUO Series User Manual

Nespresso VERTUO Series
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #55 background imageLoading...
Page #55 background image
31
9 Light blinks while machine is
running.
If coee is flowing normally, this indicates the machine is
working properly.
If only water is flowing, the machine is executing a user
request for either cleaning, descaling or emptying the
system. Refer to the corresponding paragraph in this user
manual.
Turn the machine to “OFF mode” by pushing the buon for
3 seconds and then push it again to turn the machine ON.
Now wait approximately 20 minutes to allow the machine to
cool down aer extensive use.
10 Light blinks and machine is not
running.
It will take some time before the coee flow comes out (due
to barcode reading and pre-weing the coee).
Check that a fresh capsule is inserted in correct position,
that the handle is properly locked and push the buon to
start.
Fill the water tank and push buon to start.
Turn the machine to “OFF mode” by pushing the buon for
3 seconds and then push it again to turn the machine ON.
Now wait approximately 20 minutes to allow the machine to
cool down aer extensive use.
11 Light blinks alternately 2 blinks
and 1 pause continuously.
Machine is not running.
During regular Coee/Espresso preparation: 1) Unlock the
handle and open the machine head to check that a fresh
undamaged capsule is inserted in the correct position.
2) Check that the handle is in “LOCKED” position. 3) Check
that the water tank is filled.
During Descaling, Emptying and Cleaning: 1) Check that
capsule is ejected. 2) Check that the handle is in “LOCKED”
position.
During Programming Volume: 1) Check if a capsule has been
well inserted. 2) Please refer to the corresponding chapter.
If problem persists:
1. Unlock the handle and open machine head.
2. Replace capsule (if needed).
3. Disconnect powercord from the outlet and plug the
machine back into outlet aer 10 seconds.
4. Close the head and press the buon to turn ON and press
again to start brewing. If problem persists, call Nespresso.
12 Light alternately blinking
3 times and then steady on.
Descaling needed: machine can be operated when alert
appears only a few times aer this alert before descaling
becomes necessary.
VERTUO PLUS
7b Coee leakage. Open the machine head and let the capsule be ejected.
Then perform a cleaning.
Empty and clean the cup support.
Descale if necessary.
If problem persists, call the Nespresso Club.
UM_NEW LAYOUT_VERTUO_2.indd 31UM_NEW LAYOUT_VERTUO_2.indd 31 30.03.20 11:3330.03.20 11:33

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nespresso VERTUO Series and is the answer not in the manual?

Nespresso VERTUO Series Specifications

General IconGeneral
BrandNespresso
SeriesVERTUO
Voltage120 V
Brewing TechnologyCentrifusion
Capsule RecognitionBarcode reading
Water Tank Capacity40 oz
Heat-up Time15-20 seconds
TypeCapsule Coffee Machine
Product TypeCoffee Maker
Automatic Shut-OffYes (after 9 minutes)
Compatible CapsulesNespresso Vertuo capsules
Brew SizesEspresso, Double Espresso, Gran Lungo, Alto

Related product manuals