Net.DO Lighting Control Equipment Co.,Ltd http://www.netdo.com.cn
TG24/48 LIGHTING CONTROLLER PAGE: 10
current control.
z Trigger mode of the current Chase. (The chase has 2 Trigger mode)
Auto: The speed of chase is controlled by SPEED%
and CROSS%.
Music: The chase running with music.
Press the MODE key continuously and the chase mode will be changed as
circulation.
z The Auto mode of current chase: SPEED% and CROSS%
1. This SPEED% fader is used to control the speed of current Chase, ranges from
0-100%, 0% most slowly and 100% fastest.
2. This CROSS% fader is used to control the fade of Chase-step, ranges from
0-100%, 0% most slowly and 100% fastest.
5 Initializtion of data
Steps:
1. Hold down PROGRAM key and switch on the power till LCD screen displays
“=== PASSWORD ===”
2. Press number keys 1, 2, 3, 12 at the same time.
3. The system will restart automatically after initializtion.
Special function
Notice: Please keep this paper. If you forget the password, please contact with the retail store
to ask for help.
(A) The steps of using password to start:
1.
Hold down PROGRAM key and switch on the power.
till LCD screen displays “=== PASSWORD ===”
2. Press number keys 1, 2, 11, 12 at the same time.
(B) The steps of canceling the starting password:
Repeat the above two steps.
z When the password is enabled, every time when the controller is started the
password is needed:
Press number keys 1, 2, 11, 12 at the same time.
To Previous Page
Loading...