What to do if Netafim Industrial Equipment's original hydraulic conditions are still not restored after checking the dosing booster?
If the original hydraulic conditions in your Netafim Industrial Equipment are still not restored, loosen the dosing booster's bleeding screw and wait until a stable flow, free of air-bubbles, is obtained, then retighten the bleeding screw.
What to do if Netafim Industrial Equipment's original hydraulic conditions are still not restored?
If the original hydraulic conditions in your Netafim Industrial Equipment are still not restored, have a qualified electrician check the dosing booster to verify if it functions correctly and rotates in the correct direction.
What to do if cleaning doesn't fix the dosing valve clogging in Netafim NETAJET 4G?
If, after cleaning, there is still no improvement with the dosing valve in your Netafim Industrial Equipment, replace the dosing valve.
What to do if Netafim NETAJET 4G does not function at all?
If the NetaJet™ 4G does not function at all, have a qualified electrician check the overload protection breaker.
What to do if Netafim Industrial Equipment rotameter reading shows low fertilizer/acid flow rate?
If the Netafim Industrial Equipment rotameter reading indicates a low fertilizer/acid flow rate, check and calibrate the EC and pH sensors.
What to do if Netafim NETAJET 4G controller warns about low fertilizer/acid flow rate?
If the Netafim Industrial Equipment controller is showing a low fertilizer/acid flow rate warning, check and calibrate the EC and pH sensors.
What to do if Netafim NETAJET 4G controller warns about high pH?
If the Netafim Industrial Equipment controller is showing a high pH warning, check and calibrate the EC and pH sensors.
What to do if Netafim Industrial Equipment controller warns about low EC?
If the Netafim Industrial Equipment controller is showing a low EC warning, check and calibrate the EC and pH sensors.
Details on the Bypass system for pressurized-line water source.
Details on the Bypass system for storage-tank water source.
Details on the high-flow bypass system for pressurized-line water source.
Actions for addressing issues affecting multiple dosing channels.
Troubleshooting steps for problems with individual dosing channels.
Steps to take when the NetaJet™ 4G is not actively operating.
Troubleshooting when the entire NetaJet™ 4G system is non-operational.
Causes and solutions for vibrations occurring during NetaJet™ 4G operation.
Method for calculating necessary suction reduction for accurate dosing.
Procedure for simulating dosing performance using a test bucket.
Final calibration steps performed during active irrigation.
General| Brand | Netafim |
|---|---|
| Model | NETAJET 4G |
| Category | Industrial Equipment |
| Language | English |
To Next Page
