Step 2e: Remove DIMMs
Remove the DIMMs so you can install them in the new controller.
Steps
1. Locate the DIMMs on your controller.
2. Note the orientation of the DIMM in the socket so that you can insert the replacement DIMM in the proper
orientation.
A notch at the bottom of the DIMM helps you align the DIMM during installation.
3. Slowly push apart on the two DIMM ejector tabs on either side of the DIMM to eject the DIMM from its slot,
and then slide it out of the slot.
Carefully hold the DIMM by the edges to avoid pressure on the components on the DIMM
circuit board.
20
To Next Page
Loading...
