Complete conversion for IB-iSER to/from IB-SRP, NVMe over IB, NVMe over RoCE, or NVMe over FC
After you apply the feature pack key to convert the protocol used by your InfiniBand iSER HIC port to/from
SRP, NVMe over InfiniBand, NVMe over RoCE, or NVMe over Fibre Channel, you need to configure the host to
use the appropriate protocol.
Steps
1. Configure the host to use the SRP, iSER, or NVMe protocol.
For step-by-step instructions on how to configure the host to use SRP, iSER, or NVMe, see the
Linux
express configuration
.
2. To connect the host to the storage array for an SRP configuration, you must enable the InfiniBand driver
stack with the appropriate options.
Specific settings might vary between Linux distributions. Check the
NetApp Interoperability Matrix for
specific instructions and additional recommended settings for your solution.
What’s next?
Your host protocol conversion is complete. You can resume normal operations.
130
To Next Page
Loading...
