Steps
1. Determine a location to install each drive.
2. From the front of the drive shelf, shine a flashlight into the empty drawer slot, and locate the lock-out
tumbler for that slot.
The lock-out tumbler assembly is a safety feature that prevents you from being able to open more than one
drive drawer at one time.
(1) Lock-out tumbler
(2) Drawer guide
3. Position the replacement drive drawer in front of the empty slot and slightly to the right of center.
Positioning the drawer slightly to the right of center helps to ensure that the lock-out tumbler and the
drawer guide are correctly engaged.
4. Slide the drive drawer into the slot, and ensure that the drawer guide slides under the lock-out tumbler.
Risk of equipment damage — Damage occurs if the drawer guide does not slide under the
lock-out tumbler.
5. Carefully push the drive drawer all the way in until the latch fully engages.
Experiencing a higher level of resistance is normal when pushing the drawer closed for the first time.
Risk of equipment damage — Stop pushing the drive drawer if you feel binding. Use the
release levers at the front of the drawer to slide the drawer back out. Then, reinsert the
drawer into the slot, ensure the tumbler is above the rail, and the rails are aligned correctly.
71
To Next Page
Loading...
