NetApp E2824 Install And Setup

11. Validate controller B’s network settings by entering controller B’s newly configured IP address in a browser.
If you lose the connection to controller B, you can use your previously validated connection
to controller A to reestablish connection to controller B through controller A.
Step 3: Configure storage system
After you have installed your hardware, use the SANtricity software to configure and manage your storage
system.
Before you begin
• Configure your management ports.
• Verify and record your password and IP addresses.
Steps
1. Use the SANtricity software to configure and manage your storage arrays.
2. In the simplest network configuration, connect your controller to a web browser and use SANtricity System
Manager for managing a single E2800 or E5700 series storage array.
For accessing System Manager, use the same IP
addresses that you used to configure your
management ports.
13

NetApp E2824 Specifications

General

Model	E2824
Category	Storage
Form Factor	2U
Drive Bays	24
Maximum Raw Capacity	1.8PB
Host Interface	12 Gb/s SAS
RAID Support	Yes
Hot-Swap Drives	Yes
RAID Levels	0, 1, 5, 6, 10
Power Supply	Dual redundant
Drive Type	SAS, SSD
Host Connectivity	12Gb/s SAS
Controller	Dual active controllers