NetComm 4GM3W - Page 4

NetComm
Wireless
QSG-00036 rev1
Via the Ethernet WAN port
The 4GM3W can be connected to the Internet through the Ethernet port and use a 3G/4G
USB modem as a backup connection. See the User Guide for further instructions on
conguring Automatic 3G/4G Backup. To use the Ethernet port as the primary method of
Internet access:
1. Ensure the 4G/WAN switch on the back of the router is set to WAN.
2. Connect the supplied yellow Ethernet cable to the WAN/LAN port.
3. Connect the other end of the Ethernet cable to your external network (e.g. ADSL router).
4. Follow the instructions in the Connecting to the router with WiFi section to connect
your devices to the router.
USING THE TELSTRA IPWAN SERVICE
The Telstra IPWAN Mobile Broadband services require a username and password, issued to
you by Telstra at the time of purchase, which must be entered in your 3G/4G Dual Band AC
WiFi Router before use. Please follow the steps below to setup your Telstra connection:
1. Login to the web based management console by opening your web browser (Internet
Explorer/Firefox/Safari) and type http://192.168.20.1 into the address bar
2. At the login screen, type admin into the username and password eld and then click
the Login button to continue. The First-time Setup Wizard is displayed.
3. Click the Switch to advanced view link at the bottom of the page.
4. Click the Network Setup menu at the top of the page, select the rst menu option
labelled Network Setup.
5. From the WAN Type drop down list, select Mobile Broadband if it’s not already selected.
6. In the APN eld, enter the APN required for your service (i.e. telstra.corp) and enter the
username and password as supplied by Telstra.
7. Next to the NAT option, clear the Enable checkbox to disable NAT Masquerading.
8. Click the Save button at the bottom of the page to store the new conguration settings
and connect to the Telstra IPWAN Mobile Broadband service.