Netgate Netgate-6100 - 1.4 Input and Output Ports

Security Gateway Manual Netgate-6100
Connecting to the Console
There are times when accessing the console is required. Perhaps GUI console access has been locked out, or the
password has been lost or forgotten.
See also:
Connecting to the Console Port Connect to the console. Cable is required.
Tip: To learn more about getting the most out of your Netgate appliance, sign up for a pfSense Plus Training course
or browse our extensive Resource Library.
1.4 Input and Output Ports
1.4.1 Networking Ports
The WAN1 and WAN2 Combo-Ports are shared ports. Each has an RJ-45 port and an SFP port. Only the RJ-45 or the
SFP connector can be used each port.
Note: Each port, WAN1 and WAN2, is descrete and individual. You can use the RJ-45 connector on one port, and
the SFP connector on the other.
Port Interface Name Port Name Port Type Port Speed
2 WAN1 ix3 RJ-45/SFP 1 Gbps
3 WAN2 ix2 RJ-45/SFP 1 Gbps
4 WAN3 and WAN4 ix0 and ix1 SFP+ 10 Gbps
5 LAN1 - LAN4 igc0 - 3 RJ-45 2.5 Gbps
© Copyright 2022 Rubicon Communications LLC 11