Security Gateway Manual Netgate-6100
3. Connect to the console port of the Netgate device.
4. Insert the memstick into an open USB port and boot the system.
5. After a minute the pfSense
®
Plus loader menu will be displayed with a 3 second timer. Either allow the menu
to timeout or press 1 (the default) to continue.
6. Console options are presented for serial console installation. The default option is vt100.
Please choose the appropriate terminal type for your system.
Common console types are:
ansi Standard ANSI terminal
vt100 VT100 or compatible terminal
xterm xterm terminal emulator (or compatible)
cons25w cons25w terminal
Note: Choosing the default vt100 will work, but using cons25w on the Netgate 7100 will be easier to read.
7. The installer will automatically launch and several options will be presented. On Netgate firewalls, choosing
Enter for the default options will complete the installation process.
Note: Options such as the type of disk partition can be modified through this installation if required.
8. The installer will then prompt to choose the type of system being installed, which pre-configures device-specific
defaults. Choose the option that exactly matches the unit being reinstalled. If the model is unknown, check the
sticker on the bottom of the unit.
9. Once the installer is finished, choose No and press Enter to skip going to a shell.
10. The installer will then prompt to Reboot the system. Select Reboot and press Enter. The system will shutdown
and reboot.
© Copyright 2022 Rubicon Communications LLC 33
To Next Page
Loading...
