Security Gateway Manual SG-3100
With the rules all in place, now click Apply Changes to finish and activate the new rules.
After the configuration, the rules should look like the following figure:
Fig. 9: Example firewall rules for isolated LAN type segment
Tip: Rule separators are useful for documenting a ruleset in place.
Similar to the isolated network, it’s also possible to be much more strict with rules to only allow specific outbound
ports. When creating this type of configuration,
2.6.7 Other Services
In most cases the above configuration is sufficient and clients on the new LAN can now obtain an address and get
out to the Internet. However, there may be other custom settings which need accounted for when adding a new local
interface:
• If the DNS resolver has specific interface bindings, add the new interface to the list.
• If using ALTQ traffic shaping, re-run the shaper wizard to include this new LAN type interface.
• Consider using captive portal to control access the interface
2.7 Factory Reset Procedure
The Netgate 3100 firewall appliance does not have a hardware button to reset the configuration to factory defaults. On
this device it is still possible to perform a Factory Reset from GUI or Console.
See also:
• Factory Reset from GUI or Console
The linked document has complete details but the procedure can be summarized as follows:
Reset from the console:
• Connecting to the Console Port or SSH
• Choose menu option 4 to reset to factory defaults
• Confirm the action and allow the appliance to reboot
© Copyright 2022 Rubicon Communications LLC 59
To Next Page
Loading...
Need help?
General
