15
Set Up Your System
Position Mode
Position mode is available only when the camera is not streaming, recording motion,
or in Motion Detection mode.
¾ To place your camera in Position mode:
1. Tap the Arlo icon
on your mobile device.
If you are using a computer, enter arlo.netgear.com in the address bar of a
browser.
If you are using a mobile device that supports Touch ID, you are prompted to
enable Touch ID or skip.
2. Click or tap Settings.
The Settings page displays.
3. Under Camera Settings, select the camera to position.
4. Click or tap Position Mode.
The camera starts streaming video.
Note: In Position mode, the camera streams video as fast as possible, without buering,
so that you can aim the camera while watching on a smartphone and make near real-time
adjustments to the camera position. This means that you might see lower-quality video
while the camera is in Position mode.
To Next Page
Loading...
