Installing the Gateway
1. Check that a coaxial cable is already connected to a cable wall outlet or RF splitter (optional).
2. Connect the other end of the coaxial cable to the Cable connector on the C3700.
Use your hand to tighten the connectors to avoid damaging them.
3. Connect the Ethernet cable to an available Ethernet port on the C3700.
4. Connect the other end of the Ethernet cable to the Ethernet port on your computer.
Optional: Repeat steps 3 and 4 for an additional computer or other network device that you
want to install as a wired connection on your home network.
5. Connect the power cord to the Power port on the C3700.
6. Plug the other end of the power cord into an electrical wall outlet.
.
Establish an Internet Connection
Although your computer may already be configured to automatically access the Internet, you should
still perform the following gateway connectivity test to verify that the devices were connected properly.
1. Power ON the computer connected to the C3700 if it is turned off, and then log in.
2. Contact ATMC to activate (provision) the C3700. You may have to provide the HFC MAC ID
listed on the gateway label.
3. After the C3700 is activated, open a web browser (Internet Explorer, Google Chrome, Firefox,
or Safari) on your computer.
To Next Page
Need help?
General
Weight and Dimensions
