e. Select an Ethernet port aggregation mode (note that Ethernet port aggregation
is disabled by default):
•
Enable (LACP-IEEE 803.3ad). The router communicates with the device
connected to Ethernet ports 4 and 5 on your router, and checks to see if
Ethernet port aggregation is supported on the device. If Ethernet port
aggregation is supported, the router automatically trunks Ethernet ports 4
and 5. If not, Ethernet ports 4 and 5 work as independent Ethernet ports. We
recommend that you select this mode unless your NAS or switch can support
static LAG only.
•
Static. If your device supports a static link aggregation group (LAG) only,
select this mode. Otherwise, we recommend that you to select the Enable
(LACP-IEE 803.3ad) radio button instead.
Note: You must enable static mode before you connect your device to
Ethernet ports 4 and 5 on the router.
f.
Click the Apply button.
Your settings are saved.
View or Change the Modem Router Ethernet Port
Aggregation Mode
To view or change your modem router's Ethernet port aggregation mode:
1.
Launch a web browser from a computer or mobile device that is connected to the
router network.
2.
Enter http://www.routerlogin.net.
A login window opens.
3. Enter the router admin user name and password.
The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > Ethernet Port Aggregation.
The Ethernet Port Aggregation page displays.
5. Select an Ethernet port aggregation mode:
User Manual62Manage Network Settings
Nighthawk AX6 AX2700 WiFI Cable Modem Router Model CAX30
To Next Page
Loading...
Need help?
General
