NETGEAR DG834G Setup

1
How do I setup my Netgear DG834G router?
This guide assumes the Netgear router is receiving an ADSL signal and is connected to the
computer using the provided Ethernet cable.
We'd recommend that you also read our guide to securing your Netgear wireless
connection once you're all set up.
Please note: It's normally a good idea to hard reset your Netgear router before attempting a
setup. This is especially the case if you've made several attempts to complete the setup and failed.
Hard reset your Netgear router
1. Make sure your router is switched on, and carefully push something thin, like a pin, into the
small reset hole in the back of the router
2. Hold the reset button in for at least 15 seconds and then release

NETGEAR DG834G Specifications

Physical Interfaces

LAN Ports	Four (4) 10/100 Mbps autosensing, Auto Uplink™ RJ45 ports
WAN Port	ADSL RJ11, T1.413, G.DMT, G.Lite, ADSL 2+, ITU Annex A
Wireless	802.11g Access Point auto rate capable up to 54 Mbps

Operating Environment

Operating Temperature	32º to 104º F (0º to 40º C)
Operating Humidity	90% maximum relative humidity, noncondensing
Power Adapter	12 VDC, 1A; plug is localized to country of sale

Weight and Dimensions

Dimensions	6.9 x 1.1 x 4.7 in (175.3 x 27.94 x 119.4mm)
Weight	0.7 lb (0.3 kg)