NETGEAR DG834G Instructions

1. Cabling
1.1 Make sure you have your modem cabled correctly
before going further.
You will need to cable the modem as it’s shown on the
diagram below.
2. Configuration
2.1 Enter 192.168.0.1 into the address bar on a web
browser page (e.g. Internet Explorer). A login prompt
will then ask for a username and password. Enter the
username as admin and password as password.
2.2 The first time you log in to your modem router, the
Setup Wizard prompts you to select your country and
language. Select Australia for country and English for
language and push Next.
2.3 On the next page it would ask you to change the
Router password. Push Next, unless you want to
change the default router password. If you do change
the password make sure that you note it down.
2.4 The modem router attempts to detect your
Internet connection type:
2.5 The Setup Wizard detects VeeTel's configuration.
The protocol it should detect is PPPoE or PPPoA. You
will have to enter your username and password that
you have nominated when you signed up for the
service. Click Connect and wait for the router to reboot

NETGEAR DG834G Specifications

Physical Interfaces

LAN Ports	Four (4) 10/100 Mbps autosensing, Auto Uplink™ RJ45 ports
WAN Port	ADSL RJ11, T1.413, G.DMT, G.Lite, ADSL 2+, ITU Annex A
Wireless	802.11g Access Point auto rate capable up to 54 Mbps

Operating Environment

Operating Temperature	32º to 104º F (0º to 40º C)
Operating Humidity	90% maximum relative humidity, noncondensing
Power Adapter	12 VDC, 1A; plug is localized to country of sale

Weight and Dimensions

Dimensions	6.9 x 1.1 x 4.7 in (175.3 x 27.94 x 119.4mm)
Weight	0.7 lb (0.3 kg)