Wireless-N 300 Modem Router DGN2200 User Manual
Configuring Your Internet Connection 1-3
v1.0, March 2010
• Checking for Firmware Updates screen. After initial configuration, this screen displays
unless you previously cleared the Check for Updated Firmware Upon Log-in check box.
If the wireless-N modem router discovers a newer version of the firmware, you are asked if
you want to upgrade to the new firmware (see “Upgrading the Firmware” on page 4-1 for
details). If no new firmware is available, the following message displays.
• Router Status screen. The Router Status screen displays if the wireless-N modem router has
not been configured yet or has been reset to its factory default settings. See “Router Status and
Usage Statistics” on page 4-5.
You can use the Setup Wizard to automatically detect your Internet connection as described in
“Using the Setup Wizard” on page 1-4, or you can bypass the Setup Wizard and manually
configure your Internet connection as described in “Viewing or Manually Configuring Your
ISP Settings” on page 1-5.
Figure 1-2
Note: If the wireless-N modem router is not configured (is in its factory default state)
when you log in, the Setup Wizard displays. See “Using the Setup Wizard” on
page 1-4.
Figure 1-3
To Next Page
Loading...
