NETGEAR DGN2200v3

12
ReadySHARE Access
After installation and set up, you can insert a USB storage device into
the USB port on the modem router
and share the contents with other
network users. (If your USB device has special drivers, it is not
compatible.)
Note: If your USB device requires a power supply, you have to use it
when connecting your USB device to a NETGEAR router or gateway.
It may take up to 2 minutes before the USB drive is ready for sharing
after it is connected to the router.
To access your USB device:
On Windows systems, use any of these methods:
• Select Start > Run and enter \\readyshare in the dialog box.
Click OK.
• Open Explorer or Safari and enter \\readyshare in the address
bar.
• Open My Network Places, and enter \\readyshare in the address
bar.
On Mac systems, do this:
1. Select Go > Connect to Server.
2. Enter smb://readyshare as the Server Address.
3. Click Connect.