Factory Settings and Technical Specifications
46
AC750 WiF Range Extender
Factory Default Settings
To reset the extender to factory default settings, you can use the Factory Reset button on
the side panel or you can log in and click the onscreen RESET button. For more information,
see Return the Extender to Its Factory Default Settings on page 37.
The following table shows the factory default settings.
Table 2. Factory default settings
Feature Default Settings
Smart Setup Enabled
WiFi communication Enabled
WiFi network name (SSID) NETGEAR_EXT
Security Disabled
Transmission speed Auto
1
1. Maximum WiFi signal rate (IEEE Standard 802.11). Actual throughput can vary. Network conditions and
environmental factors, including volume of network traffic, building materials and construction, and network
overhead lower actual data throughput rate.
Country/region Varies by region
Operating mode 802.11a/b/g/n/ac
Data rate in the 2.4 GHz band 54/145/300 Mbps
Data rate in the 5 GHz band 54/145/300/433 Mbps
DHCP Client enabled
To Next Page
Loading...
