19
A login page displays.
5. Select Settings > Connected Devices.
The Connected Devices page displays the MAC addresses and
virtual MAC addresses for the extender, wired devices, and
WiFi devices that are connected to the extender.
6. On the router, add the extender’s virtual MAC addresses and
all the virtual MAC addresses of the devices connected to the
extender to your router’s MAC lter table.
7. Enable the router’s MAC lter, wireless access control, or ACL.
I am connected to NETGEAR_EXT and launched a browser. I
can’t see the NETGEAR installation assistant. What can I do?
Try these troubleshooting steps:
• Make sure that your WiFi-enabled computer is set up to use
DHCP (most are).
• Make sure that the Client Link LED is green and that you’re
using a valid IP address.
• Relaunch the web browser and enter www.mywiext.net in
the address eld. Enter your email and password and click the
LOG IN button.
To Next Page
Loading...
Need help?
General
