JJA; Reviewed:
SPOC 5/17/2007
Solution & Interoperability Test Lab Application Notes
©2007 Avaya Inc. All Rights Reserved.
8 of 20
NETGEARAppNotes.doc
Select the Power over Ethernet Configuration (POE in the left window). The default values
should be adequate, but should be verified (see Figure 4).
Figure 4: NETGEAR FS726TP PoE Configuration
If the Admin Mode is not Enable, select the port and Enable PoE from the Admin pull-down
menu. Select Apply after selecting Enable.
Figure 5: NETGEAR FS726TP PoE Enabled
To Next Page
Loading...
