Need help?Do you have a question about the NETGEAR GS108T - ProSafe - Gigabit Smart Switch and is the answer not in the manual?
General| Model | GS108T |
|---|---|
| Product Line | ProSafe |
| Form Factor | Desktop |
| Power Supply | External Power Adapter |
| Layer | Layer 2 |
| Switching Capacity | 16 Gbps |
| Forwarding Rate | 11.9 Mpps |
| PoE | No |
| Storage Temperature | -20 to 70°C (-4 to 158°F) |
| Humidity | 10% to 90% non-condensing |
| Ports | 8 x 10/100/1000 |
| Management | Smart |
| MAC Address Table Size | 8K entries |
| Remote Management Protocol | SNMP, RMON, HTTP, HTTPS |
| Features | VLAN support, QoS, IGMP snooping |
| Compliant Standards | IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x |
| Operating Temperature | 0 to 50°C (32 to 122°F) |
| Certifications | CE, FCC |
| Jumbo Frame Support | Supported, up to 9, 000 bytes |
Target audience and required skills for manual users.
Guidance on navigating and utilizing the manual's content effectively.
Explains typographical conventions and the manual's coverage.
Lists essential hardware and software for switch management.
Overview of Web interface and Discovery utility for switch control.
Step-by-step guide to installing the switch in a network with a DHCP server.
Explains setup for switches in networks lacking a DHCP server.
Procedure for assigning static IP addresses to the switch.
Methods for accessing the switch's management interface via a web browser.
Process for upgrading the switch's application software.
Steps to access and log into the switch's management interface.
Explains the main tabs for navigating switch functions.
Viewing and changing configurable system settings like name and location.
Setting the system IP address source and optional management VLAN.
Synchronizing system time using SNTP or manual settings.
Configuring Simple Network Management Protocol (SNMP) settings.
Configuring Link Layer Discovery Protocol for network device discovery.
Setting port speed, duplex mode, and flow control.
Configuring Link Aggregation Groups (LAGs) for static trunking or LACP.
Understanding and configuring Virtual Local Area Networks (VLANs).
Configuring Rapid Spanning Tree Protocol (RSTP).
Configuring IGMP snooping, static multicasting, and group membership.
Configuring jumbo frame support.
Managing static and dynamic MAC addresses on the switch.
Classifying traffic and mapping priorities for QoS.
Controlling bandwidth of ingress and egress traffic for a port.
Securing management access via passwords, RADIUS, and authentication types.
Configuring RADIUS server settings for authentication.
Configuring 802.1x port authentication and guest VLANs.
Assigning storm rate limitations to the system.
Configuring port learning for unknown source MAC address packets.
Limiting IP addresses that can access the switch.
Displaying information from each port's internal counters.
Displaying information about EAP packets processed on a port.
Mirroring traffic from ports to a destination port.
Configuring and managing system logs (RAM, Flash, Server).
Performing device reboots, factory resets, and file management.
Accessing online help, support, and user guides.
Lists the technical specifications of the GS108T Gigabit Smart Switch.
Overview of switch features and their default configurations.
Explains packet handling and configuration for 802.1Q VLANs.
Describes port-based VLAN configuration and traffic confinement.
Guidelines for installing Category 5 UTP cabling for Fast Ethernet.
Lists the electrical requirements for Category 5 UTP cable.
Factors affecting 1000BASE-T performance over Category 5 cable.
Details RJ-45 plug/connector usage and pin assignments.
To Next Page