GS108T Smart Switch Software Administration Manual
4-6 Configuring Switching
v1.0, December 2007
.
2. From the LAG ID drop-down list, select 1 or 2.
3. Click Unit 1. A screen similar to the following displays.
4. Select up to four ports for membership in the LAG by selecting the check boxes below the port
numbers.
5. Click Apply to confirm any settings changes.
Advanced—LAG Configuration
The Advanced LAG Configuration screen is identical to the Basic LAG Configuration screen. See
“Basic—LAG Configuration” on page 4-4.
Advanced—LAG Membership
The Advanced LAG Membership screen is identical to the Basic LAG Membership screen. See
“Basic—LAG Membership” on page 4-5.
Figure 4-3
Figure 4-4
To Next Page
Loading...
