NETGEAR GS108T - ProSafe - Gigabit Smart Switch - Advanced-VLAN Configuration; Advanced-VLAN Membership; IEEE 802.1 Q VLAN Membership

GS108T Smart Switch Software Administration Manual
4-12 Configuring Switching
v1.0, December 2007
5. Perform one of the following actions:
• To add a VLAN:
– Select the check box to the left of one of the VLAN IDs.
– Enter a VLAN name in the VLAN Name field.
– Click Add.
• To delete a VLAN:
– Select the check box to the left of the VLAN ID that you want to remove.
– Click Delete.
• To change a VLAN name:
– Select the check box to the left of the VLAN ID that you want to change.
– Enter a new name in the VLAN Name field.
– Click Apply.
Advanced—VLAN Configuration
The Advanced VLAN Configuration screen is identical to the Basic VLAN Configuration screen.
See the previous section.
Advanced—VLAN Membership
The VLAN Membership screen lets you set the VLAN membership of each port. The screen
functions differently for port-based VLANs than it does for IEEE 802.1Q VLANs.
IEEE 802.1Q VLAN Membership
To configure VLAN membership for IEEE 802.1Q VLANs:
1. Select Switching > VLAN > Basic > VLAN Membership. A screen similar to the following
displays.
Note: By default, every port is a member of VLAN 1, which has a port VLAN ID
(PVID)
of 1.