GS108T Smart Switch Software Administration Manual
4-22 Configuring Switching
v1.0, December 2007
• Multicast Entry. Shows the Layer 2 group multicast address.
• Port Members. Shows the membership that is associated with the group.
5. Click Apply to confirm any settings changes.
Static Multicasting
Static multicast addressing provides a way to add or delete static multicast addresses that are
related to a VLAN. To configure static multicasting:
1. Select Switching > Multicast > Static Multicasting. A screen similar to the following displays.
2. The following information about static multicasting is displayed. Both the VID and Multicast
Entry fields are configurable:
• ID. Shows the static multicast ID.
• VID. Specifies the VLAN ID (VID). Select an existing VID from the drop-down list.
• Multicast Entry. Specifies the Layer 2 multicast address. Enter a multicast address in the
01:00:5E:XX:XX:XX format.
3. Perform one of the following actions:
To add a multicast entry:
a. Select a VID.
b. Enter the Layer 2 multicast address.
c. Click Add.
Figure 4-18
To Next Page
Loading...
