GS108T Smart Switch Software Administration Manual
4-24 Configuring Switching
v1.0, December 2007
b. To assign a port to or remove it from the static multicast group, select the check box under
an individual port number.
5. Click Apply to confirm any settings changes.
Switch Configuration
The Switch Configuration menu lets you to enable or disable the Jumbo Frame support. The
default frame size is 1518 bytes. When jumbo frame support is enabled, the frame size can vary
from 64 to 9,728 bytes.
Jumbo Frame Configuration
To configure jumbo frame support:
1. Select Switching > Switch Configuration > Jumbo Frame Configuration. A screen similar to
the following displays.
Figure 4-20
Figure 4-21
To Next Page
Loading...
