NETGEAR ProSafe Plus GS108PE User Manual

ProSafe Plus 8-Port Gigabit Switch
with 4-Port PoE GS108PE
Step 2. Connect power Step 3. Check status
Optional
modem
Step 1. Connect equipment
GS108PE
Optional router
Computer Server
Internet
Installation Guide
Off
On
Power LED
Port LEDs
Activity (blinking)
No link (off)
1000 Mbps link
(both LEDs)
10 Mbps link
(right LED)
100 Mbps link
(left LED)
PoE LEDs
PoE in use
No PoE use (off)
PoE not provided
(slow blinking)
PoE halted
(fast blinking)
Less than 7W of PoE
power is available
PoE Max. LED
PoE ports are
working normally (off)
PoE MAX LED was
active in the previous
2 minutes (blinking)
GS108PE IG_21Sept2012.fm Page 1 Friday, September 21, 2012 12:13 PM

NETGEAR ProSafe Plus GS108PE Specifications

General

Model	GS108PE
Category	Switch
Ports	8
PoE Ports	4
PoE Budget	53W
Switching Capacity	16 Gbps
Forwarding Rate	11.9 Mpps
MAC Address Table Size	4K
Jumbo Frame Support	Yes
VLAN Support	Yes
QoS	Yes
PoE Standard	802.3af
Power Supply	External
Certifications	CE, FCC, VCCI, C-Tick
Management	Web-based
Dimensions	158 x 102 x 28 mm
Operating Temperature	0°C to 40°C (32° to 104°F)
Storage Temperature	-20°C to 70°C
Humidity	90% relative humidity, non-condensing
Weight	0.7 kg

Summary

Check Switch Status

Power and PoE LED Indicators

Explains the status of Power and PoE LEDs on the switch.

Port LED Indicators

Describes the meaning of different Port LED states for network activity.

Configure the Switch

Install Configuration Utility

Steps to install the ProSafe Plus Utility software on your computer.

Configure the Switch via Utility

Instructions for configuring the switch using the ProSafe Plus Utility.

Product Specifications

Technical Support Information