NETGEAR ProSafe GS108P User Manual

ProSafe 8-Port 10/100/1000 Gigabit Switch
with 4-Port PoE GS108P
Installation Guide
Step 2. Connect power Step 3. Check status
Optional
modem
Step 1. Connect equipment
GS108P
Optional router
Computer Server
Internet
Off
On
Power LED
Port LEDs
Activity (blinking)
No link (off)
1000 Mbps link
(both LEDs)
10 Mbps link
(right LED)
100 Mbps link
(left LED)
PoE LEDs
PoE in use
No PoE use (off)
PoE not provided
(slow blinking)
PoE halted
(fast blinking)
Less than 7W of
PoE power is
available
PoE Max. LED
PoE ports are working normally (off)
PoE MAX LED was
active in the previous
2 minutes (blinking)
GS108Pv1_IG_18Sept2012.fm Page 1 Friday, September 21, 2012 12:02 PM

NETGEAR ProSafe GS108P Specifications

General

Model	GS108P
Category	Switch
Ports	8
PoE Ports	4
PoE Budget	53W
Switching Capacity	16 Gbps
Energy Efficient Ethernet	Yes
Fanless	Yes
Forwarding Rate	11.9 Mpps
VLAN Support	Yes
Quality of Service (QoS)	Yes
MAC Address Table	4000
Operating Temperature	0°C to 50°C
Humidity	90% maximum relative humidity, noncondensing
Jumbo Frame Support	9, 216 bytes