Need help?Do you have a question about the NETGEAR ProSAFE GS105Ev2 and is the answer not in the manual?
General| Model | GS105Ev2 |
|---|---|
| Category | Switch |
| Ports | 5 |
| Port Type | Gigabit Ethernet |
| Form Factor | Desktop |
| VLAN Support | Yes |
| QoS | Yes |
| Jumbo Frame Support | Yes |
| Power Supply | External power adapter |
| Switching Capacity | 10 Gbps |
| Forwarding Rate | 7.4 Mpps |
| Management | Web-based management |
| Operating Temperature | 32°F to 104°F (0°C to 40°C) |
| Storage Temperature | -20° to 70°C |
| Humidity | 90% maximum relative humidity, noncondensing |
| Weight | 0.3 kg |
Lists compatible switch models for this manual.
Covers connecting, installing utility, and accessing switch management.
Details changing the default switch password via browser or utility.
Explains setting static IP addresses and managing DHCP mode for the switch.
Guides on customizing IGMP snooping for efficient multicast traffic handling.
Describes configuring LAG membership and enabling LAGs for increased bandwidth and redundancy.
Details enabling QoS based on packet header priority for traffic prioritization.
Explains assigning priority levels to traffic on a per-port basis.
Covers setting rate limits and broadcast storm control for traffic management.
Introduces VLANs and covers creating basic port-based VLANs.
Details creating 802.1Q VLANs, including basic and advanced setups.
Covers adding ports to VLANs and configuring port PVIDs for traffic control.
Guides on managing flow control and configuring port speeds or disabling ports.
Details enabling loop detection and power saving options on the switch.
Covers procedures for upgrading switch firmware and remotely rebooting the device.
Explains saving, restoring, and resetting switch configurations to factory defaults.
Describes enabling port mirroring and viewing switch operational information.
Guides on viewing and clearing port traffic statistics and error counts.
Covers registering the product and using the cable diagnostic feature.
Provides steps to resolve subnet conflicts when accessing the switch.
Details how to reset the switch to its original factory default configuration.
To Next Page