Manage and Monitor the Switch
66
ProSAFE Gigabit Web Managed (Plus) Switches
7. If the firmware release notice specifies that you must reconfigure the switch, save the switch
configuration settings.
For more information about how to save the switch configuration, see Save the Switch
Configuration on page 67.
8. Select System > Maintenance > Firmware Upgrade.
The Firmware Upgrade page displays.
9. Click the BROWSE button and locate and select the firmware file.
10. Click the APPLY button.
WARNING:
To avoid the risk of corrupting the firmware, do not interrupt the
upgrade. For example, do not turn off the switch or disconnect it.
When the upgrade is complete, your switch restarts. The upgrade process typically takes
about three minutes.
Reboot the Switch
You can reboot the switch remotely.
Use Browser-Based Access to Reboot the Switch
To reboot the switch:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that is
off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the Switch Using a Web
Browser on page 7.
The login window opens.
4. Enter the switch’s password in the password field.
The switch’s default password is password.
The Switch Information page displays.
5. Select System > Maintenance > Device Reboot.
The Device Reboot page displays.
To Next Page
Loading...
Need help?
General
