Manage Network Settings
19
ProSAFE Gigabit Web Managed (Plus) Switches
Use Browser-Based Access to Specify a VLAN for IGMP
Snooping
You can specify a VLAN for IGMP snooping only if you enabled port-based or 802.1Q-based
VLANs (see Chapter 4, Use VLANS for Traffic Segmentation).
To specify a VLAN for IGMP snooping:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that is
off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the Switch Using a Web
Browser on page 7.
The login window opens.
4. Enter the switch’s password in the password field.
The switch’s default password is password.
The Switch Information page displays.
5. Select System > Multicast.
6. Make sure that the IGMP Snooping Status Enable radio button is selected.
7. In the VLAN ID Enabled for IGMP Snooping field, enter the ID of the VLAN.
By default, if you enable IGMP snooping, snooping occurs on VLAN 1. However, you can
enable snooping on any VLAN:
• For port-based VLANs, you can enter a VLAN ID from 1 to the maximum number that
you switch supports (5, 8, 16, or 24).
• For 802.1Q-based VLANs, you can enter a VLAN ID from 1 to 4094.
8. Click the Apply button.
Your settings are saved.
To Next Page
Loading...
Need help?
General
