Need help?Do you have a question about the NETGEAR ProSAFE GS108Ev3 and is the answer not in the manual?
General| Model | GS108Ev3 |
|---|---|
| Category | Switch |
| Switching Capacity | 16 Gbps |
| Forwarding Rate | 11.9 Mpps |
| MAC Address Table Size | 4K |
| Jumbo Frame Support | 9, 216 bytes |
| VLAN Support | Yes |
| QoS | Yes |
| Power over Ethernet (PoE) | No |
| Fanless Design | Yes |
| Power Supply | External power adapter |
| Ports | 8 Gigabit Ethernet ports |
| Management | Web-based management |
| Energy Efficient Ethernet (EEE) | Yes |
| Operating Temperature | 0° to 40°C (32° to 104°F) |
| Storage Temperature | -20° to 70°C (-4° to 158°F) |
| Humidity | 90% maximum relative humidity, noncondensing |
| Dimensions | 6.22 x 4.02 x 1.10 in (158 x 102 x 28 mm) |
Lists all supported ProSAFE Gigabit Web Managed (Plus) Switch models.
Explains initial setup and connection options for the switch.
Guides on connecting and configuring the switch via a web browser interface.
Configures the switch's IP address, subnet mask, and gateway.
Optimizes multicast traffic forwarding using IGMP snooping.
Combines multiple Ethernet links into a single logical link for redundancy.
Configures QoS based on 802.1p or DSCP packet header priority.
Assigns priority levels to traffic on specific switch ports.
Controls ingress and egress traffic rates for each port.
Explains Virtual LANs and their role in network segmentation.
Steps to create and assign ports to basic port-based VLANs.
Guides on creating 802.1Q VLANs with basic configurations.
Instructions for updating the switch firmware for new features and fixes.
Process for saving current switch settings to a configuration file.
Resets the switch to its original factory settings for troubleshooting.
Uses a diagnostic feature to check network cable health and fault location.
Fixes IP subnet conflicts preventing access to the switch.
To Next Page