NETGEAR ProSAFE GS108Ev3 User Manual

Manage Network Settings
20
ProSAFE Gigabit Web Managed (Plus) Switches
Use the ProSAFE Plus Utility to Specify a VLAN for IGMP
Snooping
You can specify a VLAN for IGMP snooping only if you enabled port-based or 802.1Q-based
VLANs (see Chapter 4, Use VLANS for Traffic Segmentation).
 To specify a VLAN for IGMP snooping:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that is
off-network using an Ethernet cable.
2. Double-click the ProSAFE Plus Utility icon.
The Switch Selection page displays a list of Web Managed (Plus) switches that it
discovers on the local network.
3. Select the switch.
If you do not see the switch, click the REFRESH button.
4. Click the APPLY button.
You are asked to enter the password for the switch.
5. Enter the switch’s password in the password field.
The switch’s default password is password.
The Switch Status page displays.
6. Select System > Multicast.
The previous figure is an example. Your switch might support more or less VLANs for
IGMP snooping.
7. Make sure that the IGMP Snooping Status Enable radio button is selected.
8. In the VLAN ID Enabled for IGMP Snooping field, enter the ID of the VLAN.

NETGEAR ProSAFE GS108Ev3 Specifications

General

Model	GS108Ev3
Category	Switch
Switching Capacity	16 Gbps
Forwarding Rate	11.9 Mpps
MAC Address Table Size	4K
Jumbo Frame Support	9, 216 bytes
VLAN Support	Yes
QoS	Yes
Power over Ethernet (PoE)	No
Fanless Design	Yes
Power Supply	External power adapter
Ports	8 Gigabit Ethernet ports
Management	Web-based management
Energy Efficient Ethernet (EEE)	Yes
Operating Temperature	0° to 40°C (32° to 104°F)
Storage Temperature	-20° to 70°C (-4° to 158°F)
Humidity	90% maximum relative humidity, noncondensing
Dimensions	6.22 x 4.02 x 1.10 in (158 x 102 x 28 mm)