Manage and Monitor the Switch
60
ProSAFE Gigabit Web Managed (Plus) Switches
The previous figure is an example. Your switch might provide more or less ports.
Note: To navigate to this page, select System > Status > Switch Status.
6. For each port that you want to configure, in the Speed menu, select one of the following
options:
• Auto. The port speed is set automatically after the switch determines the speed using
auto-negotiation with the link partner. This is the default setting.
• Disable. The port is shut down.
• 10M Half. The port is forced to function at 10 Mbps with half duplex.
• 10M Full. The port is forced to function at 10 Mbps with full duplex.
• 100M Half. The port is forced to function at 100 Mbps with half duplex.
• 100M Full. The port is forced to function at 100 Mbps with full duplex.
7. Click the APPLY button.
Your settings are saved.
Enable Loop Detection
If loop detection is enabled and the switch detects a loop, both LEDs of a port blink at a
constant speed.
Use Browser-Based Access to Enable Loop Detection
To enable loop detection:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that is
off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the Switch Using a Web
Browser on page 7.
The login window opens.
4. Enter the switch’s password in the password field.
The switch’s default password is password.
The Switch Information page displays.
5. Select System > Management > Loop Detection.
The Loop Detection page displays.
To Next Page
Loading...
Need help?
General
