Manage and Monitor the Switch
70
ProSAFE Gigabit Web Managed (Plus) Switches
Use the ProSAFE Plus Utility to Restore a Saved Switch
Configuration
To restore the switch configuration that you saved:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that is
off-network using an Ethernet cable.
2. Double-click the ProSAFE Plus Utility icon.
The Switch Selection page displays a list of Web Managed (Plus) switches that it
discovers on the local network.
3. Select the switch.
If you do not see the switch, click the REFRESH button.
4. Click the APPLY button.
You are asked to enter the password for the switch.
5. Enter the switch’s password in the password field.
The switch’s default password is password.
The Switch Status page displays.
6. Select System > Maintenance > Restore Configuration.
The Restore Configuration page displays.
7. Click the BROWSE button.
8. Find and select the configuration file (a .cfg file).
9. Click the APPLY button.
The saved configuration is restored to the switch. The switch reboots to load the restored
configuration.
Restore Factory Default Settings
You can return the switch to its factory settings.
Use Browser-Based Access to Restore Factory Settings
To restore factory settings:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that is
off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
To Next Page
Loading...
Need help?
General
