NETGEAR ProSAFE GS108Ev3 User Manual

Manage and Monitor the Switch
69
ProSAFE Gigabit Web Managed (Plus) Switches
The Switch Status page displays.
6. Select System > Maintenance > Save Configuration.
The Save Configuration page displays.
7. Click the BROWSE button.
8. Select the location to save the configuration file (a .cfg file).
9. Click the APPLY button.
The switch configuration is saved.
Restore a Saved Switch Configuration
You can restore switch configuration that you saved.
Use Browser-Based Access to Restore a Saved Switch
Configuration
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that is
off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the Switch Using a Web
Browser on page 7.
The login window opens.
4. Enter the switch’s password in the password field.
The switch’s default password is password.
The Switch Information page displays.
5. Select System > Maintenance > Restore Configuration.
The Restore Configuration page displays.
6. Click the Browse button and locate and select the saved configuration file (a .cfg file).
7. Click the Apply button.
The saved configuration is restored to the switch.

NETGEAR ProSAFE GS108Ev3 Specifications

General

Model	GS108Ev3
Category	Switch
Switching Capacity	16 Gbps
Forwarding Rate	11.9 Mpps
MAC Address Table Size	4K
Jumbo Frame Support	9, 216 bytes
VLAN Support	Yes
QoS	Yes
Power over Ethernet (PoE)	No
Fanless Design	Yes
Power Supply	External power adapter
Ports	8 Gigabit Ethernet ports
Management	Web-based management
Energy Efficient Ethernet (EEE)	Yes
Operating Temperature	0° to 40°C (32° to 104°F)
Storage Temperature	-20° to 70°C (-4° to 158°F)
Humidity	90% maximum relative humidity, noncondensing
Dimensions	6.22 x 4.02 x 1.10 in (158 x 102 x 28 mm)