GS108T Smart Switch Software Administration Manual
6-18 Monitoring, Maintenance, and Help
v1.0, December 2007
Factory Default
The Factory Default screen lets you reset the switch to its factory default values:
1. Select Maintenance > Reset > Factory Default. A screen similar to the following displays.
2. Under Factory Default, select the check box.
3. Click Apply to restart the switch.
Figure 6-12
Warning: If there is no DHCP server on the network, the IP address becomes
192.168.0.239.
Warning: The password returns to the factory default password.
Note: You can also use the Factory Defaults button on the front panel of the Smart Switch
to reset the switch to its factory default values.
To Next Page
Loading...
