EasyManuals Logo

NETGEAR GS108T - ProSafe - Gigabit Smart Switch User Manual

NETGEAR GS108T - ProSafe - Gigabit Smart Switch
140 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #91 background imageLoading...
Page #91 background image
GS108T Smart Switch Software Administration Manual
Configuring QoS and Security 5-19
v1.0, December 2007
The following fields are displayed. Except for the Port field, all fields are configurable:
Port. Shows the port number.
Learning Mode. Specifies whether the learning mode is enabled on the port. The possible
field values are:
Lock Disable. Specifies that the learning mode is enabled on the port, allowing
unknown source MAC address packets to be learned. This is the default value.
Lock Enable. Specifies that the learning mode is disabled on the port.
Action. Specifies the action that must be taken for unknown source MAC address packets.
This field is available only when port learning is disabled. The possible field values are:
Forward. Specifies that unknown source MAC address packets must be forwarded.
Discard. Specifies that unknown source MAC address packets must be discarded.
Limited Learning. Specifies that unknown source MAC address packets must be
dynamically learned, but with a limit of 16 MAC addresses. After 16 MAC addresses,
learning stops.
3. Click Apply to confirm any settings changes.
Access
The Access menu lets you set up IP access lists and trusted source MAC addresses.
IP Access List
The IP Access List screen lets you limit the IP addresses that can access the management portion
of the switch. The switch responds only to requests from computers with an IP address in the list,
so include your IP address and corresponding subnet mask to set this feature.
To configure your IP Access list:
1. Select Security > Access > IP Access List. A screen similar to the following one displays.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR GS108T - ProSafe - Gigabit Smart Switch and is the answer not in the manual?

NETGEAR GS108T - ProSafe - Gigabit Smart Switch Specifications

General IconGeneral
ModelGS108T
Product LineProSafe
Form FactorDesktop
Power SupplyExternal Power Adapter
LayerLayer 2
Switching Capacity16 Gbps
Forwarding Rate11.9 Mpps
PoENo
Storage Temperature-20 to 70°C (-4 to 158°F)
Humidity10% to 90% non-condensing
Ports8 x 10/100/1000
ManagementSmart
MAC Address Table Size8K entries
Remote Management ProtocolSNMP, RMON, HTTP, HTTPS
FeaturesVLAN support, QoS, IGMP snooping
Compliant StandardsIEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature0 to 50°C (32 to 122°F)
CertificationsCE, FCC
Jumbo Frame SupportSupported, up to 9, 000 bytes

Related product manuals