NETGEAR FVS338 User Manual

FVS338 ProSafe VPN Firewall 50 Reference Manual
1-6 Introduction
v1.0, September 2006
Router Front Panel
The ProSafe VPN Firewall 50 front panel shown below contains the port connections, status
LEDs, and the factory defaults reset button.
The table below describes each item on the front panel and its operation.
Figure 1-1
Table 1-1. Object Descriptions
Object Activity Description
Power LED On (Green)
Off
Power is supplied to the router.
Power is not supplied to the router.
Test LED On (Amber)
Blinking (Amber)
Off
Test mode: The system is initializing or the initialization has failed.
Writing to Flash memory (during upgrading or resetting to defaults).
The system has booted successfully.
MDM LED On (Green)
Blinking (Green)
Off
The serial port has successfully connected to an ISP and received an
IP Address.
Server data is being transmitted or received by the serial port.
The serial port has no link.
Internet
LEDs
Link/Act LED
On (Green)
Blinking (Green)
Off
The WAN port has detected a link with a connected Ethernet device.
Data is being transmitted or received by the WAN port.
The WAN port has no link.
100 LED
On (Green)
Off
The WAN port is operating at 100 Mbps.
The WAN port is operating at 10 Mbps.
Local
LEDs
Internet
LEDs
Modem
LED
Power
LED
Test
LED

NETGEAR FVS338 Specifications

General

Brand	NETGEAR
Model	FVS338
Category	Switch
Language	English