NETGEAR GSS116E Hardware Installation Guide

•
Store-and-forward transmission.
•
Flow control to minimize packet loss and frame drops.
•
Half-duplex backpressure control.
•
Per-port status LEDs and system status LEDs.
•
Per-port PoE status LEDs and system PoE Max LED for model GSS108EPP only.
•
NETGEAR green power-saving features:
-
Energy efficiency mode that fully conforms to the IEEE802.3az standard.
- Per-port automatic change to a lower power mode when the port link is down.
Among the key software features, the switch provides traffic management and multicast
efficiency:
•
Traffic management:
- Dynamic MAC address management.
- IEEE 802.1Q–based or port-based VLAN.
- QoS based on weighted round robin (WRR).
-
Port-based and IEEE 802.1p–based Quality of Service (QoS).
-
QoS based on Type of Service (ToS).
- DSCP support.
- Rate limiting.
•
Multicast efficiency:
-
IGMP snooping, v1, v2 and v3 (source filtering is not supported).
-
Blocking of unknown multicast traffic.
- Static multicast router port.
Certain features such as USB charging ports, link aggregation, and PoE+ ports are
available on specific switch models, as follows:
•
USB charging ports. See USB charging ports (model GSS108E) on page 18.
•
Link aggregation . See Static LAG connections (models GSS116E and GSS108EPP)
on page 20.
•
PoE+ ports. See PoE applications (model GSS108EPP) on page 21.
Hardware Installation Guide8Introduction
8-Port and 16-Port Gigabit Ethernet (PoE+) Smart Managed Plus Click Switch

NETGEAR GSS116E Specifications

General

Brand	NETGEAR
Model	GSS116E
Category	Switch
Language	English