NETGEAR HA311 User Manual

7
♦
Windows XP, 2000, ME, NT 4.0 or Windows 98 Second Edition installed.
Related NETGEAR IEEE 802.11a Products
♦
HE102 802.11a Wireless Access Point
♦
HA501 802.11a Wireless CardBus Adapter
♦
HR814 802.11a Cable/DSL Internet Gateway Router
About This Guide
This User’s Guide will show you how to install and use NETGEAR’s HA311
802.11a Wireless PCI Adapter. With a few simple steps, you can connect your
PCs to create a flexible and reliable network.
Get Started Now!
The HA311 802.11a Wireless PCI Adapter is easy to install. You need only to
complete these five steps, which should take about 10 to 15 minutes:

Install the HA311 utility software.

Install the HA311 Wireless PCI Adapter.

Install the HA311 Wireless PCI Adapter driver.

Configure the HA311 network settings.

Test the network connection status.
To begin the installation process, turn to page 8, Chapter 2—Installation.

NETGEAR HA311 Specifications

General

Radio Data Rate	6, 9, 12, 18, 24, 36, 48, 54, 72 for Turbo mode (Auto rate capable)
Encryption	40-bit (also called 64-bit), 128-bit or 152-bit WEP data encryption
Frequency	5.15 ~ 5.25 GHz (lower band) for US/Canada, Japan 5.25 ~ 5.35 GHz (middle band) for US/Canada
Operating Range:	Outdoor environment Indoor environment @ 6 Mbps 1200 ft. 300 ft. @ 54 Mbps 100 ft. 60 ft.
Environmental Specifications	Operating temperature: 0 to 60° C Operating humidity: 5-95%, non-condensing
Bus interface	32-bit PCI
Provided drivers	Microsoft Windows 98SE, NT 4.0, 2000, Millennium, XP
Status LEDs	Power and Network
Electromagnetic Compliance	FCC Part 15 Class B and Class E
Warranty	Limited 3-year warranty

Weight and Dimensions

Dimensions	L: 174.3 mm (6.9 in) W: 133.7 mm (5.3 in) H: 21.6 mm (0.85 in)
Weight	102 g (3.8 oz)